|
keatingofchicago.com
DIGITAL TIMER PROGRAMMING FOR AUTOLIFT
HEADS
The electronic timers provide a clearly visible and
accurate display and are very easy to use. Three dif-
ferent, independent cook times can be set using this
timer - T1, T2 and T3. When cook time has reached
“00:00”, the cooking head will automatically raise.
PROGRAMMING
To program the timers, the unit must be in the idle
mode. Press and hold the set button for approximate-
ly two seconds. The display will show “SEt”. Press
T1, T2 or T3 for the cook time to be programmed.
The display will show the current setting for that cook
time. Use the up or down button to increment or
decrement the setting. When the setting is correct,
press and hold the set button again for approximately
two seconds. The display will show "StO" for ap-
proximately two seconds and the timer will return to
normal operation. Repeat the process as necessary
for the other timers.
OPERATING LOGIC
When the timer is powered up, the display will show
the time setting for the channel that was operated
last and the relay output contacts will be open. To
start a cycle, press the desired cook time button
(T1, T2 or T3). The display will begin to countdown
from the preset time setting and the relay output
contacts will close. During the countdown the colon
will fl ash at a one-second rate. When the countdown
has reached "00:00" the relay output contacts will
open, the display will fl ash, and the audible alarm will
sound. To cancel the audible alarm, press any button.
PAUSE FEATURE
To pause a cycle in progress, press any button. The
relay output contacts will open, the display will fl ash,
and the countdown will pause. To resume the count-
down, press any button. The display will resume the
normal countdown and the relay output contacts will
close.
SHUTDOWN
Turn On/Off switch to “OFF” position.
CLEANING PROCEDURES
A. Keating Cooking Sheets
Clean cooking sheets with a damp soft cloth after
each run of product (a Turkish towel works best).
THE COOKING HEAD WILL BE HOT. USE PROPER
CARE WHEN CLEANING THE COOKING SHEETS.
End of day cleaning:
Before the griddle is turned off for the day, the cook-
ing sheets should be cleaned as described below.
Wear heat resistant gloves for maximum safety during
the entire cleaning procedure.
1. At the end of the day, wipe the cooking sheet
in place with a damp soft cloth. Continue wiping
until the surface of the cooking sheet is free of any
residue.
2. Remove the cooking sheet from the cooking
head. Clean the cooking head and the griddle
surfaces.
3. Wash the cooking sheet with a mild detergent in
warm water and dry thoroughly.
4. If needed, after the cleaning is complete, reverse
the cooking sheet and reattach it to the cooking
head.
B. Cooking Sheet Clips
To remove the stainless steel cooking sheet clips for
cleaning, simply lift them off. They can be cleaned in
a dishwasher.
C. Cooking Head
The Miraclean® surface is very durable and with
proper care, following the procedures below, will last
many years.
1. Scrape Miraclean® surface from front to back with
the Keating griddle scraper with Cooking Sheets
removed.
2. Clean and polish surface with Keating Klenzer on
a damp soft cotton cloth. Wipe off excess Klenzer.
NOTE: BECAUSE OF THE SUPERIOR MIRA-
CLEAN® SURFACE, THE ONLY TOOLS YOU WILL
EVER NEED TO CLEAN THE TOP-SIDE COOKING
HEAD ARE A DAMP SOFT COTTON CLOTH AND A
KEATING SCRAPER.
4
