|
keatingofchicago.com
INSTRUCTIONS FOR MICROSWITCH ADJUSTMENT
AUTO-LIFT TOP-SIDE™ ACTUATOR
See Figure 6-3
12
1. Remove the limit switch black plastic cover on the
actuator.
2. Turn on the power on unit and push the T1, T2 or T3
button on the timer. The actuator will extend the stroke
and lower head. The motor must stop and the stroke
should stop extending before it reaches its mechani-
cal stop. This movement is controlled by the top micro
switch.
3. If the motor fails to stop, manually depress the top
micro switch actuator. Disconnect power to the actua-
tor motor. Loosen the set screw (2.5mm allen wrench)
located on the top cam. Rotate the top cam clockwise,
until the switch is made (listen for audible click).
4. Tighten the set screw on the cam, using blue locktite.
5. Turn on the power and push the T1, T2 or T3 button
on the timer until it goes to the preset time. The actua-
tor will retract the stroke and raise the head. The motor
must stop and the stroke should stop retracting before it
reaches its mechanical stop. This movement is controlled
by the bottom micro switch.
6. If the motor fails to stop, manually depress the bot-
tom micro switch actuator. This will disconnect power to
the actuator motor. Loosen the set screw (2.5mm Allen
wrench) located on the bottom cam. Rotate the bottom
cam counter clockwise until the switch is made (listen for
audible click).
7. Tighten the set screw on the cam, using blue locktite.
8. Test the Top-Side head. Verify the adjustments did not
change the length of the stroke, thus preventing correct
function of the top Top-Side head. The Top-Side cooking
head must be able to reach the griddle plate. If it does
not function properly, complete steps #2 through #7.
9. Reinstall the switch cover.
Top-Side Head Down
Top-Side Head Up
Top Switch and Cam
Bottom Switch and Cam
2 SWITCHES
MOUNTED AS SHOWN
TOP SWITCH SHOWN
MICRO SWITCH ACTUATORS
FOR TOP AND BOTTOM
SWITCHES SEE #3 THRU #8
(TOP AND BOTTOM CAMS)
SEE NOTE #3 THRU #8
(SET SCREWS)
SEE NOTES #3 AND #4
FOR TOP MICRO SWITCH
AND NOTES #6 AND #7
FOR BOTTOM
MICRO SWITCH
SEE NOTE #1 AND #9
