|
keatingofchicago.com
5. Repeat process on the left side.
6. Reverse the process to remove the cooking sheet.
TIPS ON PROPER HANDLING AND USE OF COOK-
ING SHEETS
Cooking sheets should
NEVER
:
•
Be folded or creased. Be touched with sharp objects.
•
Come in contact with griddle scrapers or abrasive
pads.
•
Be placed under other equipment or objects.
Cooking sheets should
ALWAYS
:
•
Be wiped with a damp soft cotton cloth after each
run to remove any product residue.
•
Be cleaned after the griddle is shut down for the day.
The time to change a cooking sheet is when:
•
Product starts sticking to the sheet.
•
Too much carbon build-up causes a product appear-
ance, cooking or taste problem.
•
The head surface is cool.
•
The sheet is torn or ripped.
THE TOP-SIDE™ COOKING HEAD AND GRIDDLE
PLATE ARE HOT - USE PROPER CARE WHEN
CHANGING THE COOKING SHEETS.
LEVELING OF COOKING HEAD(S)
The Cooking Heads were leveled at the factory.
NOTE:
For best results, level griddle before checking.
Adjust legs or stand casters to level griddle.
REMOVAL OF COOKING HEAD
NOTE:
To identify parts, refer to page 9.
1. Turn off griddle and disconnect Top-Side™ Cooker
electric power.
2. Remove the cooking sheet by lifting off cooking
sheet mounting clips.
3. Place a layer of soft cloth and then a layer of
cardboard onto griddle plate under cooking head to
protect Miraclean® surface.
4. Raise cooking head completely to release tension
on cooking head support pin. Remove support pin
and its cotter pin and carefully lower cooking head to
protected griddle surface.
The cooking head is not supported after the cook-
ing head support pin has been removed. If dropped
the weight of the cooking head when unsupported
will cause damage to the griddle surface or injury to
personnel.
5. Do not turn the support pin in either direction.
6. To reattach the cooking head to the ram lift arm,
raise cooking head completely and replace cooking
head support pin. Insert a new stainless steel cotter
pin to secure support pin, holding support pin to
keep it from spinning.
7. Replace cooking sheet. See - “Installing a Cooking
Sheet”.
SETTING THE OFFSET ON THE THERMOSTAT
1. Turn power off to the Top-Side™ control box.
2. Push and hold (Push to Set) button on the front of
the thermostat.
3. Turn power back on to Top-Side™ control box.
4. While holding the (Push to Set) button, turn knob
to change the offset number that is displayed.
5. The higher the negative number is, the hotter the
Top-Side™ head will be. Turning the knob to a posi-
tive number will decrease the temperature of the
Top-Side™ head.
6. When you reach the desired number, keep hold-
ing the (Push to Set) button until the display starts
blinking. Then release the (Push to Set) button. If you
release the button before the display starts blinking,
you will have to start over at step one.
SERVICE DIAGNOSIS
A properly adjusted Keating Top-Side™ Cooker, with
no load, will cycle “ON” approximately every 5-1/2 to
6-1/2 minutes. Each cycle will last 40 seconds, ensur-
ing that the temperature setting is held within a narrow
range.
TROUBLE SHOOTING
The following diagnosis is only to be used as a guide
to qualifi ed service personnel. Keating recommends
that you use a qualifi ed & licensed service company.
(Equipment still under warranty requires it.) Call
1-800-KEATING if you need assistance in locating a
qualifi ed service company.
NOTE:
To correctly and quickly diagnose the system, the
chart below should be followed in sequential order.
6
