5
INSTALLATION REQUIREMENTS
CÁC YÊU CẦU LẮP ĐẶT
ขอกำหนดในการติดตั้ง
Please set a square inspection hole of at least 45 cm.
Do not install the product where it is exposed to oil fumes.
Do not install onto slanting ceiling.
Do not install the product in the place with many dust.
The product is not provided with, all-pole switch and leakage protection switch. Please purchase them in market.
Do not install the product where there is steam.
Do not install the product in places with high temperature.
To install the duct, avoid the following cases.
Please observe the following requirement. otherwise, it may cause the product aging and breakdown.
Vui lòng tuân thủ yêu cầu sau. Nếu không, sản phẩm có thể bị lão hóa và bị hỏng.
กรุณาปฏิบัติตามขอกำหนดตอไปนี้ ไมเชนนั้น อาจทำใหผลิตภัณฑเสื่อมสภาพและชำรุดเสียหาย
Không lắp đặt sản phẩm ở nơi có hơi nước.
อยาติดตั้งผลิตภัณฑในตำแหนงที่มีไอน้ำ
Không lắp đặt sản phẩm ở những nơi có nhiệt độ cao.
อยาติดตั้งผลิตภัณฑในตำแหนงที่มีอุณหภูมิสูง
Be sure to provide an appropriate opening for air intake.
Đảm bảo tạo khoảng hở phù hợp cho đường gió vào.
ตรวจสอบใหแนใจวามีชองเปดที่เหมาะสมเพื่อใหอากาศเขามา
Để lắp đặt ống dẫn, hãy tránh các trường hợp sau.
เมื่อติดตั้งทอ ใหหลีกเลี่ยงกรณีตอไปนี้
Không lắp đặt sản phẩm ở nơi có nhiều bụi.
อยาติดตั้งผลิตภัณฑในตำแหนงที่มีฝุนจำนวนมาก
ผลิตภัณฑนี้ไมไดมีสวิตชหลายทางและสวิตชปองกันไฟรั่วใหมาดวย กรุณาเลือกซื้อจากในทองตลาด
Công tắc đóng ngắt mọi cực và cầu dao chống rò điện không được cung cấp kèm sản phẩm này. Vui lòng mua các thiết bị này ngoài thị trường.
Vui lòng để lỗ vuông kiểm tra rộng ít nhất 45 cm.
กรุณาติดตั้งชองตรวจสอบรูปสี่เหลี่ยมจัตุรัสที่มีขนาดอยางนอย 45 ซม.
Không lắp đặt sản phẩm ở nơi tiếp xúc với hơi dầu.
อยาติดตั้งผลิตภัณฑในตำแหนงที่สัมผัสกับไอน้ำมัน
Không lắp đặt sản phẩm lên trần nghiêng.
อยาติดตั้งเขากับเพดานที่ลาดเอียง
Prevent the water condensed in the
duct pipe flow back into the body.
Ngăn nước đọng trong ống dẫn chảy ngược vào thân máy.
ปองกันไมใหน้ำที่ควบแนนภายในทอไหลกลับเขาไปในเครื่อง
请遵守以下安装要求事项，否则有可能会导致机体老化或发生故障。
请勿安装在有蒸汽的场所。
请设置一个45cm以上的方形点检口。
请勿安装在油烟过多的场所。
请勿安装在高温场所。
请设置通风口。
请勿安装在倾斜的天花板上。
防止水通过安装管道倒流。
安装管道应该避免以下情况：
请勿安装在灰尘较多的场所。
本产品没有附带电源全极开关和漏电保护开关，需用户另购。
安装要求
Within 500 mm /
Above 40 ˚C
Trong khoảng
500 mm
ภายใน 500 มม.
Trên 40 °C
สูงกวา 40
°
C
高于40℃
500mm以内
Corrugated pipe
Adapter
assembly
Cụm đầu nối
ชุดทอตอ
Ống gấp nếp
ทอยน
接头
波形管道
INSTALLATION CAUTIONS
The product must be mounted on
to the ceiling which is enough strong,
If the ceiling is not enough strong it
must be reinforced for it to be strong
enough.
Otherwise, the product may fall
down and it may cause injury.
Do avoid the back-flow of gas into
the room from the open flue of
flammable gas or other open-fire
appliances.
Components must be installed
tightly.
Otherwise, it may injure person
caused by product's falling off.
The product must be installed
tightly.
Otherwise, it may injure person
caused by product's falling off.
Please wear the gloves when
installing the product.
Otherwise, it may cause damage.
The special-purpose or dedicated
parts, such as mounting fixtures,
must be used if such parts are
provided.
The lowest surface of this product
should be installed above 2.3 m from
the floor after installation.
Malaysia market:
The lowest surface of this product
should be installed above 2.5 m from
the floor after installation.
Do not reconstruct this product.
CAUTION
It is possible to cause fire hazards
in case of leak.
The product should be installed so
that the metal parts of the product
and mounting screw do not contact
any metallic members in the ceiling,
such as metal laths, wire laths and
metal plate .
