KBS Proxima M Series, Инструкция по установке и эксплуатации

Страница: 8 / 65

7
Operator's guide:
1)Unpacking instructions
2)Opening the protective cover
3)Cleaning the internal basin
4)Cleaning the cover and external parts
5)Holders for containers and pastry shelves
6)Support shelves
7)Connection to the mains
8)Controls
9)Checking correct operation
10)Internal and evaporator cleaning
Maintenance manual (Page 48):
1)Cleaning the condenser
5)Wiring diagram diagram of refrigeration unit
2)Replacement of the lamp
3)Access to the motor compartment
4)Replacement of the cover's lifting motor
WARNINGS
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it.
2
3
4
5
6
7
. It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice.
8 9
10
11
12
13
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance
near sources of heat, such as radiators, stoves, etc. . Keep the ventilation grills free from obstruction
for at least 30 cm. . Ensure that the products displayed on the shelves and grills do not hang over the
edges. . If damp air or products to be refrigerated should cause ice to form on the evaporator, we
recommend stopping the compressor and placing the goods in special refrigerated containers, kept at the
same temperature, until defrosting is completed;if this is not carried out the compressor will continue to
operate leading to a wasteful consumption of electricity and poor performance.
. If the appliance is not
working and unused, it is indispensable to keep the door open at least 10 cm.
Our products are for internal use only do not install outside restaurants, shops.
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a.
WOODEN CRATE 1b.
2
3. 4. 5
6.
7 8
2. OPENING THE PROTECTIVE COVER
1.
2
3. CLEANING THE INTERNAL BASIN
1
2
3
4. CLEANING THE COVER AND EXTERNAL PARTS
1.
2 3
4
5. HOLDERS FOR CONTAINERS AND PASTRY SHELVES
1
2
3
4.
. 5.
6. SUPPORT SHELVES
Cut surrounding tape. Remove the cardboard package by sliding it upwards.
Remove the nails from the wooden crate with care. . Insert forks of forklift truck
between the appliance and pallet or crate. Lift the appliance. Remove the pallet or crate. . Place
the appliance on a flat, level surface. Make sure there is nothing left in the package before disposing of
it. . Sort out the packaging materials in order to facilitate disposal. . The appliance can be locked in
place by engaging the wheel brakes (see fig. 1).
Plug the machine into the power supply socket, as described in Chapter 7. . Turn the switch of the
electric lifting system (A) to position II until the cover is fully (see fig. 2).
. Remove the protection film from the stainless steel parts. . Clean the basin with a soft sponge and
neutral detergents. . Remove the plug on the rear side of the machine to drain any residual water.
Never use detergents containing alcohol or solvents which would irremediably damage the cover,
compromising its transparency. . Use only a soft damp sponge. . As far as the wooden surfaces are
concerned, use proprietary detergents especially designed for wooden surfaces, which are water-based
and do not contain solvents. . Dry with a clean cloth.
. Remove the protection film from the holders. . Place the longer holders in the slots provided on the
basin's rims. . Place the shorter holders in the slots provided in the longer holders. Different
arrangements are available for different container sizes and positions.
You can now put your containers
on the holders For pastry models, you need only place the stainless steel shelves on the rims
(containers and stainless steel shelves are available upon demand) (see fig. 3).
Take hold of the bottom edge of the shelf and turn upwards (A) until the shelf is horizontal. Push down the
edge near to the basin (B) until the shelf is firmly secured in place (see fig. 4).
!
!
UK