KBL megaSun 7900 Alpha, Руководство по эксплуатации

Страница: 41 / 64

Maintenance intervals
Component/
wearing part
Cleaning/care Replacement
Condensate
tank
If a corresponding
message is
displayed.
When required
Air filter
Depending on local
conditions after
approx. 100 oper-
ating hours
-
Tubes
- Smart
technology
- CPI
After approx. 200
operating hours
Typical value after
about 1100 oper-
ating hours. For
further information
see data sheet.
Tubes
- Electronic
Power
After approx. 200
operating hours
Typical value after
about 800 oper-
ating hours. For
further information
see data sheet.
Facial tanners When required
After approx. 500
- 600 operating
hours
LED booster
After approx. 200
operating hours
When required
Acrylic pane
(bench)
When required
After approx. 1500
operating hours
Acrylic panes
(others)
When required When required
Shoulder
tanner
When required
After approx. 600
operating hours
Air-
conditioning
unit
Clean the heat
exchangers after
500 - 600 operating
hours and check the
condensate pump.
When required
Air hoses
Check after 500
- 600 operating
hours.
When required
Springs of the
canopy drive
After approx. 2000
operating hours /
1 year
After approx.
10000 operating
hours / 4 years
Ropes of the
canopy drive
Check and grease
after 500 - 600
hours.
Replace all
ropes after 3000
operating hours.
Protective
pane-switch
- Filter panes Test the switches
with each removing
of filter panes
When required
aquaCool Filter
-
After approx.
2000 operating
hour
and/or 1 year
aquaCool
nozzles
When required
After approx. 1000
operating hours
Tools and aids
4
Hexagon socket screwdriver (SW 4 / 60
mm) Art. No.: 3410055251
PH2
2x Standard Phillips screwdriver (PH2)
PH2
Phillips screwdriver (PH2) 90° offset
4
Hexagon socket spanner SW 4
19
Pipe wrench SW 19
1x Open-ended spanner SW 10
2x Open-ended spanner SW 13
Tape rule or folding rule
↵
Finally acknowledge a process by pressing
the Start button (interior control panel).
Number of trained personnel required for
this maintenance task.
Number of qualified and authorised per-
sonnel required for this maintenance task.
The following chapters describe the work steps
required for carrying out maintenance and care
actions.
At the beginning of each chapter, the required tools
and aids are depicted, unless the corresponding
process can be carried out by one individual person
without any further auxiliary equipment.
The assembly is basically carried out in
reverse order of the disassembly.
Exceptions are especially pointed out.
If you open the bench part or one of the
acrylic panes, you must, after closing,
acknowledge a warning message appear-
ing on the interior control panel.
O p e r a t i n g I n s t r u c t i o n s | megaSun 7900
α
41