A s s e m b l y I n s t r u c t i o n s
|
6808 /7908
36
5.9 Attach canopy end caps
PH2
5.9.1 OPEN CANOPY PANE
5.9.2 FASTEN CANOPY END CAPS
• Unpack both canopy end caps
(left/right) from
the box.
• Connect decorative lighting
Ⓐ
and slide the can-
opy end caps
onto the guides.
Ⓐ
• Screw on front fastener of the canopy end cap
(M6x12 - PH2).
PH2
5.9.3 CLOSE THE CANOPY PANE
5.10 Fine adjustment of the
canopy drive
19
PH2
Attention
Adjust the canopy drive only at the lower
springs!
The fi ne adjustment is made at the fac-
tory for each tanning device.
The values determined are noted on the
device feet.
These ar
e the values to be set!
If a readjustment is necessary over time, the canopy
drive must be adjusted by means of parallel adjust-
ment of the preload of the two springs, so that
the canopy stops independently in each position.