ASSEMBLY INSTRUCTIONS
continued
STEP 3: INSTALL SEAT AND SEAT POST
FOR YOUR CONVENIENCE THE SEAT ON SOME UNITS MAY HAVE
BEEN ASSEMBLED TO THE SEAT POST AT THE FACTORY.
SEAT ASSEMBLY:
1. Loosen seat clamp nut (G).
2. Insert the top portion of seat post (H) into
the seat clamp (I). Be sure the seat post is
completely inserted into the seat clamp and
butted tight against the end stop.
3. Retighten seat clamp nut on both sides (hand tight). The nut
will be securely tightened later with an adjustable wrench.
SEAT POST ASSEMBLY:
4. Insert seat post into bicycle frame. Be sure that seat post
is inserted into frame at least 2 1/2” (65mm).
CAUTION: MINIMUM INSERTION LINE SHOULD
BE COMPLETELY INSERTED INTO THE FRAME
AND NOT VISIBLE ONCE INSERTED.
5. Tighten the seat post binder bolt (J) securely at desired height to fit
the intended user.
6. Adjust angle of seat so that top of seat is parallel to the ground and
comfortable for the rider.
7. Retighten seat clamp securely with an adjustable wrench to the torque
specified below. PLEASE NOTE: Test the seat to pedal distance. The
ball of the foot of the intended rider should rest comfortably on the pedal
when it is in its lowest position. If it does not, adjust the seat height as necessary.
Check for tightness by attempting to move the seat up and down, then side to side. If the seat is loose, be sure to tighten the clamp nut
and binder bolt nut securely.
Torque 12-16 ft-lb / 17-21 N-m
J
H
G
I
12