Power/
Signal input connector
Projection panel
Speaker
Light source
detect sensor
Function buttons
Projection Sticker Tape x 1
Adhesive Band x 2
Manual x 1
Power/Signal Cable 1.8m x 1
Wire Clip x 3
HUD main device x 1
Red wire
+ DC12V
White wire
Black wire
Schematic illustration of
the usage of Wire Clips.
Push down
Original wire
External
connecting
wire
1. It’s recommended to
attach the Adhesive
Bands on two sides at
the bottom of the HUD.
2. Place the HUD in a
suitable location for
clearly projecting the
vehicle speed on the
windshield.
1. Please connect the Red wire to
the DC12V power wire behind
the power-on switch.
Black wire should be connected
to ground wire.
White wire should be connected
to speed signal wire.
2. Wire clips are recommended
while connecting.
(as shown in the following figure)
(Use pliers to press the sheetmetal and clip.)
Connect Power/Signal Cable
After complete wire connecting,
connect the Power/Signal Cable to
HUD.
Turn on the vehicle power, and all
function indicators will light up for
about 2 sec. This process is
checking
through the LED segments, then it
will enter the function mode of
displaying the speed of the vehicle.
Attach the Projection Sticker Tape
on the windshield.
Clean the windshield and spray
some water on it.
Detach the Projection Sticker,
attach it on the inner of the
windshield and scrape the
redundant water.
Screen functions
Function buttons
Speeding warning sign(Red)
Speeding warning sound(Orange)
Function mode light(Orange)
Mode Selection button
Number Up/Down button
Exit/Mute button
Place the HUD
Connect Signal/Power Cable
Package contents
＊
Vehicle speed display
＊
5 ranges speeding warning
HUD CRX-3001
