Kayoba 002-399, Руководство по эксплуатации

Страница: 37 / 65

EN
37
NOTE:
•
The belt is correctly tensioned when it can be pulled out
50 - 75 mm from the treadmill.
• Moving parts should move freely and quietly. If moving
parts are not working properly this will compromise the
safety of the product. Check all screw unions at regular
intervals and tighten them if necessary.
• Regular maintenance guarantees functionality and
prolongs the life span of the product.
• Check and retighten screw unions at regular intervals.
Recommended maintenance interval
• Short use (less than 3 hours/week): 6 months
• Moderate use (3 to 5 hours/week): 3 months
• Long use (more than 5 hours/week): 2 months
The belt is not centred
The belt may move sideways after a period of use. By allowing
the treadmill to start and run by itself the belt can centre
automatically. If it does not centre automatically you can adjust
its position by turning the screws. If the belt runs to the right –
tighten the screws on the right-hand side or loosen the screws on
the left-hand side. If the belt runs to the left – tighten the screws
on the left-hand side or loosen the screws on the right-hand side.
The belt slips
Adjust the screws as illustrated. Make sue the belt has the same
adjustment on both sides. Adjust a half turn at a time until the
belt does not slip or deviate. Do not overtighten the belt as this
could damage the belt.
FIG. 20
Transport
1. To turn the treadmill over on the transport wheels, start by
putting your hands in position D.
2. Place one foot in position F.
3. Keep your foot firmly in position F and slowly tilt the
treadmill towards you.
4. When the treadmill has been tilted it can be rolled on
transport wheels.
FIG. 21
5. To transport the treadmill it should be held in the tilted
position and rolled on the transport wheels.
FIG. 22
TROUBLESHOOTING
Fault Action
The treadmill is activated, but
nothing is shown on the display.
Check whether the overload protection is working.
Check that the power switch, overload protection and cord between the drive units and the voltage
transformer are in good condition and makes sure the connection is good.
Check that the connection between the drive unit and display are good.
The voltage transformer is faulty, replace the transformer.
The display shows E01 after
activation.
Fault on signal cable. Check that all cables between the display and drive unit are in a good condition.
Fault in components/parts in the display.
Fault in the transformer.
The display shows E02 after
activation.
Check that the motor cable is in good condition, if not replace the motor cable. If it does not work
have the motor checked at a service centre.
Check the control unit.
Check that the input voltage is correct.
The display shows E04 after
activation.
Check that the signal cable to the incline motor is in good condition, pull out the connection and
insert it again.
Check that the power cord to the incline motor is in good condition.
Check whether the power cord to the incline motor is faulty, replace the power cord or have the
incline motor checked at a service centre.
The circuit board may need replacing.
Press the LEARNING button to reprogramme.
The display shows E05 after
activation – overload protection.
The treadmill is overloaded.
A part can have fastened, putting excessive strain on the motor. Adjust the belt.
Check whether the motor smells or if it sounds overloaded.
Check if the circuit board is working properly.
The circuit board could be short circuited. Have the circuit board checked at a service centre.