63
Ap
p
e
n
d
ix
MIDI IN/OUT jacks
These jacks are used to connect the CE220 digital piano to
external MIDI devices, and also to a computer with a MIDI
interface or USB MIDI cable.
USB to Host port (‘B’ type)
This USB port is used to connect the CE220 digital piano to a
computer using an inexpensive USB cable. When connected, the
instrument can be used as a standard MIDI device, allowing it to
send a receive MIDI data. Connect a ‘B’ type USB connector to
the instrument, and an ‘A’ type USB connector to the computer.
Troubleshooting
Problem
Possible Cause and Solution
Page no.
Po
w
e
r
The instrument does not turn on.
Check that the AC power cable is firmly attached to the instrument, and
connected to an AC outlet.
p. 12
Sound
The instrument is turned on, however
no sound is produced when the keys
are played.
Check that the VOLUME slider is not set to the lowest position.
Check that a pair of headphones (or headphone adaptor plug) are not
connected to the PHONES jacks.
Check that the ‘Local Control’ MIDI setting is set to ‘On’.
p. 12
p. 12
p. 53
The sound distorts when playing at
very loud volume levels.
Check that the VOLUME slider is set to an appropriate level, reducing the
volume if excessive distortion is heard.
p. 12
Pe
d
a
ls
The pedals are unreliable or do not
function at all.
Check that the pedal cable is firmly connected to the instrument.
p. 60
When depressing a pedal, the pedal
board flexes and is not firm.
Check that the pedal support bolt is fully extended.
p. 13
US
B
The USB Save function does not
appear to operate correctly.
Check that the USB memory device is correctly formatted to use the
FAT/FAT32 filesystem.
Format the USB memory device using the USB Format function.
p. 35
LINE OUT jacks (1/4” phone jack)
These jacks provide stereo output of the instrument’s sound
to external speakers, amplifiers, mixers, recording devices, and
similar equipment. Mono signals will be output only if a cable is
connected to the L/MONO jack.
LINE IN jacks (1/4” phone jack)
These jacks are used to connect a pair of stereo outputs
from other electronic instruments or audio equipment to
the instrument’s speakers. The audio signal from these jacks
bypasses the MASTER VOLUME control.
The ‘USB to Device’ functionality of the CE220 digital piano
conforms to USB2.0 Hi-Speed standards. Older USB devices
can still be used, however data transfer speed will be limited
to the maximum transfer speed of the device.
The ‘USB to Device’ port is intended for connecting USB
memory devices, however USB floppy drive devices can also
be used to save recorder songs stored in internal memory, or
play SMF song files.
It may be necessary to format the USB memory device before
it can be used with the CE220 digital piano. If so, please
refer to the USB Format function instructions on page 81.
Formatting the device will erase all data.
Avoid removing the USB memory device while data is being
loaded or saved, files are being renamed or deleted, or the
device is being formatted.
Other USB devices, such as computer mice, keyboards, or
battery chargers etc. cannot be used with this instrument.
USB device information