KaVo Primus 1058 C, Инструкции по уходу, Страница: 32 / 39

2.9.2 HYDROclean function
The HYDROclean function is an automatic programme for hydro-mechanical
cleaning of the drainage and separation systems within and outside the treatment
unit. The cleaning process is carried out by the supply of fresh, clear water (limi‐
ted rinsing). The water is aspirated from the Aquamat through the filter housing to
the separation system. The spittoon bowl rinsing is alternately turned on and off.
The HYDROclean function prevents the coagulation and adhesion of proteins in‐
side the drainage system and improves the transporting of fine particles.
Carrying out the HYDROclean function:
▪ After each treatment
Requirement
Suction hoses remain hanging in the holder.
Start the HYDROclean function
Note
Make sure that the slides to the cannula holders of the suction tubes.
▶ Press the „LP/AP“ button on the dentist element.
The LEDs flash for approx. 4 seconds.
▶ While the LEDs are flashing, press the "Bowl flush" button on the dentist ele‐
ment.
This starts up the HYDROclean function. This lasts approximately 2.5 mi‐
nutes.
▶ The process can be discontinued at any time by pressing the "Bowl flush" but‐
ton.
2.10 Preparation of the amalgam separator
The following systems can be used as options:
▪ "Dürr" Amalgam separator
▪ "Assembly kit for external suction removal for connection to a central amalgam
separator"
▪ "Separation asembly kit"
Optimal care of the amalgam separation system includes the correct and regular
use of the HYDROclean function and use of DEKASEPTOL gel.
See also: 2.9 Reprocessing and automatic hygiene functions of the suction sys‐
tem, Page 29
Note
follow the instructions for use for the amalgam separator.
Care instructions KaVo Primus® 1058 S/TM/C
2 Setup methods according to DIN EN ISO 17664 | 2.10 Preparation of the amalgam separator
30/35