KaVo K-POWERgrip, Инструкция по эксплуатации

Страница: 21 / 33

Fitting the chuck
▶ Insert the chuck ② and pin ① with the original chuck key A, and tighten.
▶ Reattach the cover ①.
▶ If worn, replace the cover (three units in the care set).
▶ Remove the clamp B from the grip tip.
▶ Insert a new tool or test probe ① into the chuck as far as it will go.
▶ Grip the handpiece part 2, and turn the motor 3 in the direction indicated by
the arrow until the chuck closes completely.
6.2 Servicing
6.2.1 Replacing ball bearings
Disassembly
▶ Slowly turn the shaft in the pin ① until the clamp B can be inserted with a
slight amount of resistance into the grip tip ②.
Instructions for use K-POWERgrip Handstück 4941
6 Service and Care | 6.2 Servicing
19/29