Kato Imer CARRY 107, Руководство по эксплуатации

Страница: 20 / 54

2 INSTRUCTIONS FOR USE
MINIDUMPER
CARRY 107
11
2.2.3 STARTING OF DIESEL ENGINE
1. Check that diesel cock, under the tank, is opened.
2. Put the accelerator lever (E) in the intermediate position.
3. Turn the key (I) in “ON” position. The indicators (N) “oil
pression” and (M) “battery charge" light up.
4. Turn the key (I) in “START” position until the engine starts up.
Free the key (I) after start up. The indicators (N) and (M) switch
off. Do not operate start up engine more than 15 sec. If the
engine does not start up in 15 sec., let cool the engine during 2
minutes before restarting up. Put the key (I) in “OFF” position
before retrying to start up.
5. Decrease the engine speed to allow the warming.
2.2.4 SWITCH OFF DIESEL ENGINE
Put the accelerator lever (E) at minimum speed, put the key (I) in
“OFF” position and pull the red button “STOP” (L) till the engine
switches off.
2.2.5 DIESEL ENGINE ELECTRIC SCHEDULE
SH
EA
TH
CONNECTOR FEMALE
ON THE MOTOR
YELLOW
WHITE GREEN
RED
OIL PRESSURE
SENSOR
RED
GREEN WHITE
YELLOW
CONNECTOR MALE
ON THE STARTER CABLE
SH
EA
TH
15/54
RE
D
YELLOW
BLACK
15
30
50
GR
EE
N
WHITE
30
/1
KEY SWITCH
BLACK
CHARGE
WARNING LAMP
OIL PRESSURE
WARNING LAMP
2.2.6 FUEL SEDIMENTER
The fuel tank is equipped with a sedimentation and draining system for water found in the fuel. Any water or
other impurities that deposit in the transparent sedimenter (1) are drained through the valve (2). Check and
drain out any water and impurities every 50 hours or as needed. Turn the engine off, place a suitable pan
under the draining pipe (3), open the valve and let the polluted fuel, water and impurities flow out. Close the
valve firmly.
Note: Always dispose of drained fluids as established by local regulations.
2.3 WARMING THE MACHINE
As for all hydraulic systems, it is very important that the oil reach its operating temperature before starting
work. The time required for warming can be spent performing a few simple maintenance checks. Before
carrying out operations at full load carefully follow the instructions given below:
1
Allow the engine to warm up slowly at low speed for 5 minutes.
2 Operate the tool holder cylinder to warm the hydraulic components quicker.
N
M
I
E
L
Stop
(OFF)
Operation
(ON)
Start
(START)
KEI SWITCH
SEDIMENTER