Inserting Batteries into the Remote Control
14 of 28
5
Inserting Batteries into the Remote Control
1. Remove the cover from the remote control. To do this, press gently on the point
②
,
slide the cover
①
to the rear
③
and lift it off (Fig. 4).
2. Insert the batteries supplied
④
into the battery compartment
⑤
. Ensure correct pola-
rity of the batteries (the polarity is marked inside the battery compartment).
3. Fit the cover again and slide it forward to the stop.
4
3
2
1
4
5
Fig. 4: Inserting batteries into the remote control (showing the principle)
6
Connecting the Receiver
6.1
Requirements
This Quick Start Guide describes how to connect and commission the UFT 930.
For further information, see the comprehensive instructions for use at
www.kathrein.com
.
Contact your specialist dealer directly if you have questions or encounter problems.
DVB-T/T2-TV was developed to be able to receive a good quality TV picture anywhere,
provided the signal is strong enough.
►
To do so, connect the receiver either to your conventional stand-alone or community
antenna through which you receive all VHF/UHF signals, or use an antenna developed
for DVB-T/T2 e.g the Kathrein BZD 30 for direct reception indoors or the BZD 40 for
outdoors.
You may encounter problems in concrete buildings if you are using only an indoor
antenna.
