Kathrein UFG 300, Инструкция по эксплуатации

Страница: 11 / 28

936.3627/-/1
109/4.7
e
“Cable NIT” sub-menu
**** Cable NIT ****
NIT: Off
Compile
Network: Name ID
“Cable NIT” sub-menu (display during NIT compilation)
Cable NIT
being compiled
Please wait
□ □ □ □ ...
A B C E D E F G H I J K L M N O P Q R
S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9 _
KATHREIN WERKE KG _
“Name” sub-menu “ID” sub-menu
Network ID
FF 01
7.2.1 Setting the name and the network ID for the cable NIT
Press the “ ” and “ ” buttons to select the desired parameter “on”, “Compile”, “Name” or “ID”.
Press the “Sub-menu” button to activate the selected parameter and open the respective sub-menu.
The network name is set by adding “ ” or removing “ ” characters at the
fl ashing cursor in the third (name) line.
The character to be added is selected by using the “ ” and “ ” buttons to move the cursor within the fi rst two lines.
The maximum number of characters is 40.
Exit the menu by pressing the “Sub-menu” button ; this saves the set value.
The network ID should only be set if the operator applied for and was granted the ID by the ETSI.
The preset value (FF01) is intended for networks without a speci
fi c network ID.
The network ID is selected digit by digit using the “ ” and “ ” buttons and is changed using the “ ” and “ ” buttons.
Exit the menu by pressing the “Sub-menu” button ; this saves the set value.
7.2.2 Compiling the cable NIT, switching the cable NIT on and off
The controller carries the
NIT compilation process
through to completion after it has been started
manually with the “ ”
or
“ ” button
. The new cable NIT is created and then sent to the channel units. The procedure can be aborted by pressing the
“ ” button (leading to the error message shown below). A progress bar is displayed in the bottom line of the display during the
compilation process.
When the cable NIT is complete it is saved and can now be switched on and off as required. To do this, use the “ ” and “ ”
buttons to select the “Cable NIT” “on/off” sub-menu and use the “ ” and “ ” to make the change-over.
“Cable NIT” sub-menu
**** Cable NIT ****
NIT:
On
Compile
Network: Surname ID
“Cable NIT” sub-menu (display if aborted)
NIT error:
User abort
<Continue: key >
The following error messages may appear during cable NIT compilation:
“Cable NIT” sub-menu
NIT error
Not all channel
units registered
< Continue: key >
“Cable NIT” sub-menu
NIT error:
Insert position speci fi -
cation non-compliance
< Continue: key >