Kathrein MobiSet 4 Twin CAP 950, Руководство по эксплуатации

Страница: 15 / 52

15 of 52
3. Provisionally insert the roof duct into the drilled hole (Fig. A).
4. Place the mounting plate on the roof of the vehicle such that the centre hole is positioned centrally to the cable gland.
The arrow symbol
③
must be visible from above and point forwards in the direction of travel of the vehicle (Fig. B).
5. Mark the positions of the six fastening holes on the vehicle roof in a pitch circle.
Tip
The size of the holes and the choice of fastening screws to be used (not included in the scope of delivery)
depend on the type and thickness of the materials used in the roof structure. If the roof panelling (plastic
roofs) is sufficiently strong, it is recommended to always use round head screws, plain washers and self-
locking nuts to secure the glued mounting plate.
6. If the roof panel material is very thin and does not provide adequate holding power within the insulation material,
make through holes of Ø 5.5 mm into the interior of the vehicle and use galvanised M5 round head screws of suffi-
cient length.
Make sure that you use a sufficiently strong support that can withstand the bolt tensile forces (large plain washer or a
complete reinforcing plate).
Fig.
C
1
2
3 *
)
*
)
*
)
*
)
①
adhesive area between the
grooves
②
alternative roof fastening
③
washer*)
* ) Not included in the scope of delivery
7. Create the holes necessary to secure the mounting plate (Fig. C).
8. In addition to the screw connection, the mounting plate and roof duct must be bonded to the roof with adhesive and
sealed. This is done using the DEKAsyl MS adhesive sealant supplied, which is ideally suited for this purpose due to
its broad range of adhesion. Please note the following points:
–
Before you start working with the DEKAsyl MS adhesive sealant, it is essential that you have carefully read
through the safety data sheet for the DEKAsyl MS adhesive sealant and the technical data sheet in this
installation manual!
–
The prerequisite for good adhesive properties is a clean, dry and grease-free substrate. Therefore, clean the
roof surface with a suitable cleaning agent within a circumference of 17 cm around the drilled hole and allow the
surface to dry thoroughly.
–
If the surface is painted, ensure that the paint finish is sufficiently well bonded to the substrate.
–
If the coat of paint is already loose or peeling, remove it down to a stable layer in the area to which the adhesive
will bond. If you have any doubts concerning the adhesive properties, consult a paint and lacquer specialist or the
manufacturer of your vehicle.
9. The procedure for gluing the mounting plate is as follows:
Fig. D
Adhesive area
within the grooves