Kathrein MobiSet 4 Twin CAP 950, Руководство по эксплуатации

Страница: 18 / 52

18 of 52
Installation and Connection
7. Lay and connect the turntable cables on the mounting plate as indicated on the mounting plate, see Fig. F1. Make
sure that the cables are not crossed over and that they are taut so that they cannot be crushed. Take particular care
that the two master coaxial cables, marked red, are connected to each other.
NOTICE
Risk of material damage due to pulling the cables from the turntable!
►
Do not try to pull the cables from the unit.
8. Tighten the coaxial cable plugs finger-tight, using no tools.
9. Tighten the coaxial cable plugs lightly using an open-ended 11 AF spanner.
10. Carefully lower the turntable back on to the mounting plate. Make sure that the through holes on the turntable are
perfectly aligned with the threaded holes on the mounting plate.
11. Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening screws into the
thread. Tighten the screws to a torque of 6 Nm.
12. Run the connecting cables through the waterproof HDZ 100
1)
roof gland into the interior of the vehicle. In doing so,
make sure that the cables are not crushed, kinked or damaged.
*
)
Not included in the scope of delivery! The HDZ 100 roof gland is available as an accessory under part number 20410032 from specialist dealers.
Fig.
F1
Master coaxial cable
(marked red)
Fig. F2
1
2
3
(220)
(450)
①
When using a cable duct as a direct extension of the cable exit from the CAP, its height must not exceed
that of the cable feed system hood, i.e. 10 mm.
②
Cables laid in the cable duct
③
Roof gland HDZ 100, not included in the scope of delivery