Kathrein MobiSet 3 Twin CAP 650, Перевод оригинального руководства по эксплуатации

Страница: 23 / 56

23 of 56
NOTICE
Risk of malfunction or material damage due to overheating!
If the CAP converter is attached to another electrical device, e.g. a TV set, the temperature rise of each unit in
operation can affect the other, thus causing overheating.
►
Before installing the CAP converter on another electrical device, check with the manufacturer of the device
or in the documentation supplied with it whether this is permissible, and if so, what fittings (screws, etc.)
are necessary or can be used.
Using other Screws
If because of the installation location or factors associated with it, the
screws supplied cannot be used, refer to the figure on the right when
selecting the screws to be used. The figure shows you the cross-
section area of the screw sockets on the CAP converter. From this, it is
possible to see the characteristics of the screws which can be inserted
into the receiver support, e.g. diameter, screw head profiles etc.
6.6
5.2.4 Installing the CAP Converter on a TV Set
DANGER
Danger to life from electric shock!
If the screws penetrate too deeply into the TV set, they may damage it beyond repair and cause the risk of a
fatal electric shock.
►
Before starting any installation work, disconnect all the units concerned from the mains.
►
Before installing the CAP converter on another electrical device, check with the manufacturer of the device
or by reference to the documentation supplied with it whether this is permissible, and if so, what fittings
(screws, etc.) are necessary or can be used.
CAUTION
Risk of material damage and injuries from overheating and fire!
►
Under no circumstances install the CAP converter between a TV set and a wall support.
► Installation of the CAP converter on the rear panel of a TV set is permissible only if the TV set is resting on
a stand that is attached in some other way.
For installation on the rear panel of a TV set, securing with two screws is sufficient. Before installing the CAP converter,
pay attention to the following:
●
The TV set must have one of the following hole patterns for wall mounting on its rear panel: 100 x 100; 100 x 200;
200 x 200 or 200 x 400. If this is not the case, a VESA adaptor plate can be obtained from a specialist dealer.
●
Before installing the receiver it is essential you read the section
Wall mounting
(or the equivalent) in the user instruc-
tions for your TV set. This will tell you the screw diameters (M4, M6 or M8) and, most importantly, the permissible
screw penetration depth.