Kathrein HDS 910, Руководство по эксплуатации

Страница: 10 / 44

10
INSTALLATION AND CONNECTION
INSTALLING THE NEW CONTROL UNIT
DISCONNECTING THE CONNECTIONS TO THE OLD CONTROL UNIT
• Mark the coaxial cable that comes from the turntable to the control unit (port: “IF IN”), so that it will not
later be confused with the coaxial cable that runs to the receiver.
• Now disconnect all connections to the control unit
• Remove the old control unit
The four existing screw sockets (see diagram on the next page) allow you to attach the control unit to a solid
fl at surface.
In addition, the following points should be taken into account:
• The wall thickness at the installation location must be at least 12 mm, as otherwise the screws will break
through on the other side or damage the surface
• Ensure that the cupboard or storage compartment in which the unit is housed is adequately ventilated,
to prevent a build up of heat. Carpet-covered walls are unsuitable for installation
• Take care when tightening the screws not to damage any cables etc. behind or in the wall
• The control unit is designed exclusively for installation in dry, interior locations. The installation location
must be protected against moisture.
• The cable lengths must be taken into account when choosing the installation location
• The connecting cables must be provided with strain reliefs
Connections and fusing of the unit:
All cables for connection to the control unit are connected at the rear of the unit (see also “Views of the HDS
900 control unit” in this section). When selecting the installation location, allow suf
fi cient clearance at the
rear of the unit for these cables and their plugs.
The plug-in fuse is also located at the rear. This fuse (for the type see “Views of the HDS 900 control unit”
in this section) should be accessible even after installation, so that it can easily be exchanged if required.
Under no circumstances use countersunk-head screws for installation
(see diagram on the right), since these can damage the screw sockets
on the control unit. Wherever possible, use the wood screws supplied
with the upgrade kit.