Kask ZENITH, Инструкция по эксплуатации и уходу

Страница: 4 / 24

4
HELMET ADJUSTMENTS: Wear the helmet and adapt the size by turning the
rear wheel (clockwise to tighten the size and counter-clockwise to enlarge it) or
simply (only  or models equipped) by drawing the two quick-closing elements
to obtain the desired tension (Fig. 2). Position the size adjustment system in the
nuchal area as shown (Fig. 3), tilting it and adjusting it in height. For versions
equipped with a chin strap,  asten it by inserting one buckle strap into the other
until it clicks into place (Fig. 4a). Pull the chin strap to check that the buckle is
locked (Fig. 5). Adjust the length o  the chin-strap to  rmly secure the helmet on
your head. The rubber ring must be positioned on end o  the tape to prevent
it dangling. Adjust the lateral retractor o  the chin strap by sliding it along the
straps until you  nd the desired position below the ear (Fig. 6). To remove the
helmet  rom the head, open the chin-strap by simultaneously pressing the
buttons on each side o  the buckle (Fig. 4b).
SPARE PARTS: Changes, replacements and/or removals of one or any of the
original components o  the helmet are prohibited unless authorized by the
manu  acturer. Only use original KASK spare parts. The helmet should not be
modi  ed to accommodate other accessories other than those described below.
If necessary contact your retailer or the manufacturer directly.
ZENITH MODEL HELMET ACCESSORIES: Chin strap (only  or BA versions)
- lamp clip - visor attachment adapters - refective stickers – neck protector -
sombrero - earmu  s - eye protection visor -  ace shield - plastic mesh protector
- metal mesh protector - replacement padding - winter padding.
Check with your retailer or manu  acturer the actual availability o  the accessories
listed above. Follow the installation and operating instructions supplied with the
accessory. Only use accessories approved by the manu  acturer.
CHECK: Be  ore using the helmet check its integrity in all its parts. Following a
violent impact even i  the damage is not visible replace the helmet, as it may
have exhausted its ability to absorb  urther shocks and provide the expected
protection.
CLEANING: Clean the helmet (and any accessories) using only water, mild
soap and a soft, clean cloth, and let it air dry at room temperature. The internal
padding can be removed and washed by hand in cold water or in the washing
machine (max. 30°C -85° F). Never use chemical cleaning products or solvents.
STORAGE: When not in use, the helmet should be stored away  rom direct
sunlight and sources o  heat, and we recommend putting it back in the original
package.
MODIFICATIONS AND REPAIRS: Do not apply adhesives, solvents, stickers,
or paint that does not comply with the manu  acturer’s speci  cations. Do not
US