RGBW PUSH-BUTTON CONTROLLER MANUAL
4
LSTA BUTTON CONTROLLER
1.
The Gear button can be used to change setting mode: Pressing the gear button will display one of the
following:
•
SA = standalone mode. This is the mode we use to choose scenes on buttons 1-8 or with the -/+
buttons.
•
PA = change scene page. 10 pages (P0, P1, P2….P9) are available for a total of 80 scenes.
• This will adjust what scenes buttons 1-8 select.
•
Co = Change color. Use the – /+ buttons adjust the color from 0 to 99 this is similar to a color wheel
that will change the color from blue to green to red to white with colors in between
•
SP = Change speed of a color changing scene use the -/+ buttons to change speed from -9 – 0 – 9.
-9 is slowest, 0 is normal speed, 9 is fastest.
•
dI = Dimmer change how bright the lights are. If you go above -9 to 0 is off to normal full
brightness. 1 to 9 will add white light to the color until it is all white at 9
2.
The row of buttons 1 through 8 are for choosing scenes. Default (P0) they choose scenes 1-8. That can
be shifted to choose 9-16, 17-24, 25-32, 33-40, etc…. depending on which PA (page) is chosen.
• To change the PA (page) press the gear button until the screen shows PA, then press the + or -
button to increment from PA to P0, P1, P2, P3, P4, etc…
•
P0 = scenes 1-8, P1 = 9-16, P2 = 17=24, P3 = 25-32, P4 = 33-37 (37scenes are programmed)
3.
You can also manually increment through the scenes in Standalone mode (SA) by pressing the – or +
buttons and then the check mark button. This will activate the scene # you choose.