8
2.6 – Overhead Feeder Folder Setup:
When the
button on the System Setup page is pressed the above screen is displayed.
(On machines fitted with an overhead feeder folder in station one only. Machines without
this facility will not display this screen.)
If
is pressed, the overhead feeder folder will run in OMR mode where printed,
allowing inserts to be selected from the side stations. This capability is not fitted as standard.
If
is pressed, the overhead feeder folder will run in BATCH mode. This means that
the feeder will feed and fold a number of sheets according to the setting of the adjacent
thumbwheel. The minimum batch setting is 1 and the maximum is 5.
NOTE:
If the batch setting is greater than one and BATCH mode is selected, or if OMR mode is
selected, then the station cannot be deselected immediately by pressing CANCEL or the
station select toggle button. By pressing either of these, the station will continue feeding until
the current batch is completed (BATCH mode) or the current set is completed (OMR mode).
If the station is required to be cancelled regardless of the state of the current batch or set,
then it can be by
pressing and holding
CANCEL or the station select toggle button for one
and a half seconds. This will then force the station to be deselected.