Karel MS26S, Инструкция по установке и обслуживанию, Страница: 48 / 62

Karel MS26s Installation & Maintenance Guide
Edition 3.1
40
The following signals are present on the connection box of printer data cable .
1- Data
Signal
2- GND
3- No Connect
4- No Connect
5- Busy Signal
6- No Connect
Figure B-13
For connecting KY16 to the system, the Data / Busy / GND signals on the
connection box of the system data cable (used by LT26s(-H) Feature Phones
as well) must be wired in parallel to the corresponding pins of the connection
box of the printer data cable (see Figure B-13).
In the absence of LT26s(-H) Feature Phones connected to the system, the
method of cabling for KY16 may be simplified as follows :
1) The RJ plug at the end of the cable that comes from the printer must be
disconnected from the connection box.
2) This RJ plug must be then passed through the cable holes at the bottom
part of the cabinet and then, connected to the LT/OP socket on the MB26s
motherboard.
Figure B-14