Karel MS26S, Инструкция по установке и обслуживанию, Страница: 37 / 62

Karel MS26s Installation & Maintenance Guide
Edition 3.1
29
II. SYSTEM INSTALLATION
The MS26s system is designed to be mounted on the wall. Hence, the system
comes with a template and a pair of anchor plugs with screws.
The template has the same dimensions with the MS26s system, so that it can be
used to choose the location of the system and to determine the points of the holes
on the wall. The template also has the necessary information to hang the system
on a proper location on the wall, that is the top drill hole must be 150 cm above the
floor.
To install the system :
1) Place the template on the wall (see Figure B-1).
2) Drill 2 holes at the points marked on the template (see Figure B-1).
3) Drive the anchor plugs into the holes (see Figure B-1).
4) Insert the screws into the anchor plugs and fix the screws (see Figure B-1).
Figure B-1
5) Open the front cover by pressing the latches on the left and right sides (see
Figure B-2) and pulling the front cover (see Figure B-3).