Kärcher SP 7 Dirt, Руководство пользователя

Страница: 9 / 18

– 5
*The switching height can vary depending on the posi-
tion of the float switch.
Likewise, the cable length between the float switch and
the lock can influence the switching heights. We recom-
mend retaining the preset cable length.
 Insert the mains plug into the socket.
Illustration
 Secure the nose on the float switch into the open-
ing of the lock pointing up.
NOTICE
In manual operation the pump remains switched on
continuously.
In order that the pump draws independently in manual
operation, the fluid level must be at least 50 mm.
The pump can pump up to a residual fluid height of 35
mm.
The stated residual fluid height is only achieved in man-
ual operation.
 Insert the mains plug into the socket.
ATTENTION
Risk of damage! Dry running leads to increased wear;
never leave the pump unattended during manual oper-
ation. Switch off immediately in case of dry running.
NOTICE
Soiling can deposit and lead to malfunctions.
 Pump clear water or thoroughly rinse the pump af-
ter every use.
This especially applies after pumping chlorinated
water or other liquids that leave residue.
 Disconnect the main plug from the socket.
The pump is maintenace-free.
몇
CAUTION
In order to prevent accidents or injuries, keep in mind
the weight of the appliance during transport (see Spec-
ifications).
 Lift and carry the pump on the carrying handle.
 If you want to transport the appliance on a vehicle
secure it from slipping.
몇
CAUTION
In order to prevent accidents or injuries, keep in mind
the weight of the appliance when selecting a storage lo-
cation for it (see Specifications).
 Completely drain the pump and allow it to dry.
 Store the pump in a frost-free place.
Manual operation
Finish operation
Maintenance
Transport
Storage
Storing the pump
Special accessories
2.997-100.0 Braided hose set Flexible 1 1/4“ braided hose with hose clamp (30 - 40 mm) with wing
screw for a connection without tools.
Especially recommendable for the immersion pumps when remov-
ing large water quantities.
Max. operating pressure: 5 bar
6.997-346.0 Spiral hose, by the meter,
25 m, 1" By the meter for cutting hoses to individual lengths.
2.645-247.0 Hose PrimoFlex, 50 m, 1" Phthalate-free 1" garden hose for draining away the water.
Troubleshooting
몇
DANGER
Risk of mortal danger on account of electric shock!
To avoid risks, all repairs and replacement of spare parts may only be carried out by the authorised customer service
personnel.
Fault Cause Remedy
Pump runs but does not transport Air in the pump Unplug and plug in the mains plug of
the pump repeatedly until the fluid is
drawn
Suction area blocked Pull out the mains plug and clean the
suction area
Water level below the minimum fluid
level (only in manual operation) Immerse, whenever possible, the
pump deeper into the feed fluid or pro-
ceed as described in Chapter Opera-
tion.
Pump does not run or suddenly comes
to a standstill during operations Power supply interrupted Check fuses and electrical connec-
tions
Thermal protection switch has
switched off the pump due to over-
heating Pull out the mains plug, let the pump
cool down, clean the suction area,
prevent dry running
Dirt particles have got jammed into the
suction area Pull out the mains plug and clean the
suction area
Pumping capacity is reducing Suction area blocked Pull out the mains plug and clean the
suction area
9 EN