English
KM 100/40 W
5
UTILISATION FOR THE INTENDED
PURPOSE ONLY
♦
This sweeper is intended for
sweeping inside- and outside
surfaces.
♦
It corresponds to the L utilisation
classification for non-health
hazardous dusts.
♦
It is not intended for use on public
traffic routes
FUNCTIONAL DESCRIPTION OF
SWEEPER
The KM 100/40 W work using the
throw-over principle.
•
The sweeping strap (1) cleans
corners and edges of the sweeping
surface and transports the dirt into
the path of the main brush.
•
The rotating main brush (2)
transports the dirt directly into the
debris container (3).
•
The dust swirled up in the container
is separated by way of the dust
filter (4) and the filtered, clean air
removed by the suction turbine (5).
DEVICE ELEMENTS
1. Push handle
2. Lever for forward travel
3. Charging control indicating
instrument for batteries
4. Battery charger plug connection
5. Unit cover
6. Sweeping strap
7. Lever for lowering and raising the
sweeping strap
8. Drive wheels
9. Filter shaker for the dust filter
10. Debris container with transport
rollers and push handle
11. Latch for debris container
1. Main switch
2. Lever for lowering and raising the
coarse-dirt flap
3. Coarse-dirt flap
4. Swivel caster with parking brake
5. Cover latch
BEFORE OPERATION FOR THE
FIRST TIME
Unloading instructions
The machine was secured on a pallet
with stretch belts or ropes for safe
transport. Proceed as follows when
unloading:
Cut the plastic packing tape and
remove the film
Knock aside the wheel securing
blocks and lift the machine off the
pallet by hand
Installation
Fitting thrust clip
Positioning the sweeping belt
Install the batteries
Charge the batteries
See maintenance tasks chapter for
description
EACH TIME BEFORE OPERATION
General instructions
Park the sweep suction machine on
a level surface
Shut-off the engine
Set parking brakes on the front of
the swivel caster
Inspection and maintenance work
♦
Check the battery charge state
Master switch setting "1"
Battery indicating instrument with
deep-discharge protection
•
If red diode (1) lights, battery is flat
•
If yellow diode (2) lights, battery
charge is still 20%
•
If green diode (3) lights, battery
charge is more than 20%
Note:
The units turns off automatically in
case of deep discharging.
Recharge the battery when the
yellow or red diode is lit.
Check sweeping strap
Check the sweep roller
Clean filter
Empty the swept material container
See maintenance tasks chapter for
description
