Kärcher ICC 2 Euro 3, Руководство пользователя

Страница: 37 / 308

English
37
Î Unscrew the oil filter.
Î Clean the intake and sealing areas.
Î Coat the washer of the new oil filter with
oil before fitting it.
Î
Fit in the new oil filter and tighten it by
hand.
Î Screw in the oil drain screw along with
the new washer.
Note
Tighten the oil drain screw using a torque
wrench to 25 Nm.
Î
Fill in motor oil.
Oil grade: see Technical Data
Î Close oil filler opening.
Î Let the motor run for approx. 10 sec-
onds.
Î
Check engine oil level.
The oil level must be within the viewing
glass.
Refill oil:
Î Clean the filling area.
Î Loosen the screw cap of the oil filling
opening.
Î Refill oil.
Î Close oil filler opening.
Î Check oil level
Oil change:
Î
Ready a catch bin for appr. 1 litre oil.
Î
Unscrew oil drain plug.
Oil grade: see Technical Data
The oil level must be within the viewing
glass.
Î Clean the filling area.
Î Loosen the screw cap of the oil filling
opening.
Î Refill hydraulic oil.
Oil grade: see Technical Data
Î
Check all hydraulic hoses and connec-
tions and ensure that they are leak-
proof.
Only Kärcher Customer Service is author-
ised to carry out maintenance tasks on the
hydraulic unit.

Danger
Danger of scalding by boiling water! Let the
cooler cool down for at least 20 minutes.
Î Fill in cold water in the cooling water
compensation tank.
If the motor is cold:
– Cooling water level must be above the
lower marking.
If the motor is warm:
– Cooling water level must be below the
upper marking.
– The percentage of anti-frost agent in the
cooling water should not be more than
50%.

Danger
Risk of explosion!
– Do not carry out maintenance tasks in
closed rooms.
– Smoking and naked flames are strictly
prohibited.
Î Switch off engine.
Î Raise waste container.
Î Keep a suitable catch bin ready.
Î Loosen the fuel filter casing.
Î Empty the fuel filter casing.
Î Remove the fuel filter casing.
Î Clean or replace fuel filter.
Î Replace washers.
Î Fit the fuel filter again.
Î Check fuel tubes and clamps for dam-
ages and make sure they are leak-
proof.
Î Deaerate the fuel system
Î Raise waste container.
Î Insert the hose on the deaeration screw.
Î Turn the deaeration screw by one rota-
tion.
Î Keep a suitable catch bin ready.
Î Pump until fuel free of air bubbles is re-
leased.
Î Close the deaeration screw.
Check oil level in the water pump; refill
and change oil
Check hydraulic oil level and refill hy-
draulic oil
Check hydraulic unit
Check water cooler and maintain it.
Clean and replace fuel filter
Deaerating the fuel system