Kärcher HDS 550 C Eco, Оригинальное руководство пользователя

Страница: 18 / 754

18
English

Danger
Risk of injury! Regard to according safety
regulations when operating at gas stations
or other dangerous areas.
The spray angle is essential for the effective-
ness of the high pressure ray. Normally work is
performed with a 25° flat ray nozzle (included).
Recommended nozzles are deliverable as
accessories
– For strong contaminations
0° full ray - nozzle
– For sensitive surfaces and light contami-
nations
40° flat ray - nozzle
– For thick layered, persistent contamina-
tions
Dirt grinder
– Nozzle with adjustable spray angle, for
adaption to different cleaning tasks
Angle-Vario-Nozzle
Î Set temperature and detergent concen-
tration according to the surface to be
cleaned.
Note
To prevent damage due to too much pres-
sure, always position high pressure ray first
from a greater distance towards object to be
cleaned.
Loosen the dirt:
Î Spray detergent economically and let it
work for 1...5 minutes but do not let it dry
up.
Remove the dirt:
Î Spray off loosened dirt with the high-
pressure ray.
Removal of light contaminations and clear
rinse, i.e.: Gardening tools, terrace, tools, etc.
Î Set the appliance switch to "I".

Danger
Scalding danger!
Î Set device switch to desired temperature.
We recommend the following cleaning tem-
peratures:
– Light contaminations
30 -50 °C
– Contaminations containing protein, i.e. in
the food processing industry
max. 60 °C
– Vehicle cleaning, machine cleaning
60 -90 °C

Danger
Danger of scalding by hot water. After oper-
ation with hot water, the device must be op-
erated with openend handgun with cold
water for at least two minutes.
Î Switch low pressure nozzle to the posi-
tion "high pressure" or replace it with the
supplied high pressure nozzle.
Î Close filter of the detergent suck hose.
Î Set the appliance switch to "I".
Î Activate hand spray gun and flush device
for appr. 1 minute.
Î Set the appliance switch to "0".
Î Shut off water supply.
Î Turn on pump shortly (appr. 5 seconds)
with device switch.
Î
Pull main plug out of socket with dry
hands only.
Î
Remove water connection.
Î Activate hand spray gun until device is
pressure less.
Î Secure handgun (Figure 1 - Pos. 12).
Please do not let mineral oil contaminated
waste water reach soil, water or the sew-
age system. Perform engine cleaning and
bottom cleaning therefore only on speci-
fied places with an oil trap.
Working with the high pressure nozzle
Cleaning
Recommended cleaning method
Operating with cold water
Operating with hot water
After each operation
After operation with detergent
Turn off device