24
Maintenance
9.
Raise the motor and bracket to remove the
assembly from the pivot pin.:
10. Use a 1/8” hex key to remove the pulley and steam
shield disk from the drive motor shaft, then remove
the 1/2” bolts holding the motor to the mounting
bracket.
11. Install the new motor. Installation is the reverse of
removal.
12. Reconnect the drive chain to the turntable.
Timers and Switches on the Control Panel
Required Tools and Equipment
•
5/16" wrench or socket
•
1/2" wrench or deep socket
•
small phillips-head screwdriver
•
small flat-head screwdriver
Replacement Procedure
1.
Disconnect power to the machine.
2.
Remove control panel face plate (four 5/16”
screws).
3.
Disconnect the wiring harness from the rear of the
face plate.
4.
Remove the knob from the timer you wish to
remove.
5.
Remove the two screws, retaining nut, and o-ring
that hold the timer switch to the control panel.
6.
Detach the power leads from the timer.
7.
Attach the power leads to the new timer.
8.
Install the new timer. Installation is the reverse of
removal.
Oil Skimmer Motor
Required Tools and Equipment
•
5/16" wrench or socket
•
1/2" wrench or socket
•
small phillips-head screwdriver
CUDA 7248 Operator’s Manual 9.801-712.0 - AA
Retaining
Nuts
Screws
Steam
Shield
Disk
Hex
Bolt
Mounting
Screws
Содержание CUDA 7248
Страница 2: ...2 CUDA 7248 Operator s Manual 9 801 712 0 AA Machine Data Label...
Страница 33: ...33 Parts Parts CUDA 7248 1 043 516 0 1 043 517 0 1 043 518 0 CUDA 7248 Operator s Manual 9 801 712 0 AA...
Страница 37: ...37 CUDA 7248 Operator s Manual 9 801 712 0 AA Notes...
Страница 56: ...9 801 712 0 Printed in U S A...