Kärcher CUDA 7248, Руководство оператора

Страница: 23 / 56

23
Maintenance
6. Install the new heating element(s). Installation is
the reverse of removal.
Thermostat
Required Tools and Equipment
• 5/16" wrench or socket
• medium phillips-head screwdriver
• large flat-head screwdriver
Replacement Procedure
1. Disconnect power to the machine.
2. Remove the cover from the heating element and
thermostat enclosure (four 5/16” screws).
3. Detach the electrical leads from the thermostat.
4. Remove the thermostat from the machine.
5. Install the new thermostat. Installation is the
reverse of removal.
Turntable Motor
Required Tools and Equipment
• 5/16" wrench or socket
• 1/2" wrench or socket
• 1/8" hex key
• medium phillips-head screwdriver
Replacement Procedure
1. Disconnect power to the machine.
2. Disengage the drive chain from the turntable.
3. Taking care not to kink or tangle the chain, place it
on the turntable.
4. Remove the turntable motor cover (two 5/16”
screws).
5. Remove compression springs between the motor
and the rear wall of the wash chamber.
6. Remove the drive pulley access plate (two 5/16”
screws).
7. Reach into the drive pulley access hole with your
fingers to remove the chain from the drive
sprocket. Take care not to let the chain slip into the
wash chamber. Use a piece of wire to secure the
chain while you replace the motor.
8. Disconnect all power leads from the motor, taking
care to mark them for reassembly.
CUDA 7248 Operator’s Manual 9.801-712.0 - AA
Power Leads
Thermostat
Wire to
Secure Chain
Drive
Chain
Move Motor
Assy. Forward
to Loosen
Chain