Kärcher BD 45/40, Руководство по обслуживанию

Страница: 53 / 127

English 5.906-269.0 Rev. 00 (03/11)
53
6.8.6 Polishing (with vacuuming)
Initial use Display
Battery: E...F
Shutting down
Switch the programme selector switch (S2) to position “Polishing with vacuuming"

Drive switch (S4) switched off

Suction turbine (M2) active

Cleanspeed active ("Cleanspeed Edit" set to "1" in setup menu)

Suction turbine speed (M2) ("SUCTred Edit“ set to "1" in setup menu)
Display
Battery: E...F

Red LED "Fault" is glowing continuous-
ly

After approx. 10 seconds of overload,
the following will be shut off
–
Brush motor
–
Solenoid valve water
–
Dosing pump detergent (optional)

Display
Brush overload

Red LED "Fault" is blinking

Switch the key switch off and perform
startup
Drive and brush motor
(M1 und M2) ready
Deadman switch (S3)
actuated? No
Yes
Brush motor (M1) active
Yes
Yes Brush motor overload?
No
Drive switch (S4)
switched on? No
Yes
The drive motor (M3)
starts via the on ramp
and moves forward con-
tinuously at 4 km/h.
Continued on next page.