Kärcher ARMADA BRC 40/22 C, Руководство пользователя

Страница: 20 / 61

20
Solenoid valve removal process
In order to access the solenoids you must remove the lower deck as described in the brush motor removal section staring on page
15.
Most machines will have a finger guard over the solenoids. To
remove the finger guard you will need the #20 Torx driver to
remove the single screw holding it in place.
With the finger guard released use a 3/8” wrench to
remove the Ground wire from the guard.
Once the finger guard is removed, release the water lines from the John Guest fittings on the solenoid valve assembly by push-
ing the ring and hose in continuing to hold the ring in, pull the hose out of the fitting. It is necessary to remove the screw and
retaining clamp from the blue line to release it from the fitting. Disconnect the electrical connections.