Kapture KPT-942, Руководство пользователя

Страница: 8 / 36

8
2.2.3 Adjust the position of the Car Dash Cam
1. Loosen the knob and adjust the device
vertically and/or horizontally.
3. To remove the device, push the
release of the left side of the
mount and slide off.
2. Tighten the knob to make sure the device
is securely locked in place.
2.2.4 Mounting the Rear view camera to the Rear Windscreen
1. Remove the protective white label from
the double sided tape exposing one side
of the adhesive pad.
2. Press the adhesive pad firmly on the base
of the rear view camera.
3. Remove the protective red label from the
double sided tape exposing the other side
of the adhesive pad.
4. Press the camera base firmly to the
desired location on your rear windscreen.
Hold on the rear windscreen for 30
seconds to ensure the adhesive pad is
securely in place.
2.2.5 Connecting the Car Dash Cam to the Rear view Camera
1. Using the supplied 6M micro USB extension cable, connect one end of the cable to the port marked 2CH on the Car
Dash Cam.
2. Run the cable neatly along or under your vehicles’ interior trim to the Rear View Camera and connect the other end of the
cable to the Rear View Camera’s micro USB port.
2.2.6 Adjusting the Rear View Camera
Please use only the included charger to power and charge the built-in battery. It is advised that the Car Dash Cam is
installed near the rear view mirror, at the top centre of the windscreen for optimal operation.
Adjusting for recording out of rear windscreen:
1. Rotate the camera mounting shaft 180° away from the camera base.
2. Rotate the camera lens 180° so that it is view the rear view of your vehicle.
Adjusting for recording inside of vehicle:
1. Rotate the camera lens 180° so the camera lens is view the interior view of your vehicle.
2. Rotate the camera mounting shaft 180° so that the camera lens aligns with the camera base.
3. Adjust the view of the camera lens by rotating the camera as shown.
Note:
It is recommended to disconnect the
micro USB cable from the rear view
camera before adjusting.
180°
180°
180°
1
1
2
2
1
2