Kapsys SmartVision2, Руководство пользователя

Страница: 7 / 86

7 / 86
SmartVision2 User Guide
SmartVision2 set-up
Insert your SIM card
SmartVision2 is only compatible with Nano SIM cards (4FF format).
To insert the SIM card, flip the phone over, locate the notch on the bottom left corner, and lift
the back cover. The SIM card connector is on the right of the SOS button. To install the SIM
card, the chip should face down and the beveled corner should be placed at the top left.
Slide the SIM card upward in its slot.
Good to know: the external Micro-SD memory slot is just above the SIM card connector.
Insert the battery
Once the back cover is removed, insert the battery in its compartment by placing the edge
with the charging pads first. Then clip the bottom of the battery.
Replace the back of the phone by first engaging the upper part.
Clip firmly to close the
phone.
Charging the battery
For the very first use, we recommend charging the battery for at least 4 hours. Afterwards,
you will recharge the battery depending on your use and the discharge of the battery.
To charge the battery, you will need the USB cable and AC adaptor supplied with the
SmartVision2. First, use the USB cable to connect the SmartVision2 port to the AC
adaptor, then plug the AC adaptor into an outlet. You can also charge the product by
connecting the USB cable directly to your computer.
Caution: sole the battery, USB cable, AC adaptor and wall charger supplied by KAPSYS
are to be used. The use of unprovided accessories may cause damage and will invalidate
KAPSYS warranty.
Turn your phone on/ off
To turn your SmartVision2 on, press and hold the On/Off button located on the top edge.
When SmartVison2 vibrates, release the button.
If it does not turn on, please check if the battery has been properly installed. If necessary,
repeat the battery installation procedure.
To turn your device off, press and hold the On/Off button to display the "Main Menu" then
select "Power Off" and confirm the action. A short vibration is issued when SmartVision2 is
turned off.
The "Main Menu"
screen also offers shortcuts for “Kapsys Accessibility Service” activation,
“Screen On/Off” to save battery power, “Color inversion” to change color contrast for certain
visibility disorders. For further information on these different modes, refer to the
“Accessibility” chapters.
Standby mode
When SmartVision2 is turned on, briefly press the On/Off button to switch the device to
standby mode or wake it up (operational mode).