35
8.16 Set Ratio Head
Note:
The SET RAT. HEAD option configures the way that Ratio copy operates (see section 3.5 Ratio
on page 14).
Ratio copy duplicates only a percentage of the Master hard drive. The SET RAT. HEAD option allows
you to define a percentage of a Master hard drive to be duplicated, from the beginning of the hard
drive up to the defined percentage.
Tap
the ‘RUN’ button to change this option.
The defined percentage can be 0%, 1%, 2%, 3%, 4%, 5%, 10%, 20%, 30%, 40%, 50%, 60%, 70%,
80% or 90%. The default value is: 2%
8.17 Set Ratio Tail
Note:
The SET RAT. TAIL option configures the way that Ratio copy operates (see section 3.5 Ratio
on page 14).
Ratio copy duplicates only a percentage of the Master hard drive. The SET RAT. TAIL option allows
you to define a percentage of a Master hard drive to be duplicated, from the end of the hard drive
down to the defined percentage.
Tap
the ‘RUN’ button to change this option.
The defined percentage can be 0%, 1%, 2%, 3%, 4%, 5%, 10%, 20%, 30%, 40%, 50%, 60%, 70%,
80% or 90%. The default value is: 0%
8.18 Most Varied Capacity
Note:
The MOST VAR. CAP option configures the way that Smart copy operates (see section 3.1
Smart on page 13).
When you execute a Smart copy operation, the system will check the capacity between all connected
Target drives. Any Target drives who’s capacity exceeds the tolerance percentage defined by the
MOST VAR. CAP option will be excluded from the operation.
Tap
the ‘RUN’ button to change this
option.
For example:
•
[ 0%] : All targets must be the same capacity. Any hard drives with a capacity larger than the
smallest capacity drive connected will be excluded from the operation.
•
[10%] : After the capacity of all Target hard drives has been checked, any hard drive that has a
capacity greater than 10% of the smallest capacity hard drive will be excluded from operation.
The default value is: 3%
Set Ratio Head / Set Ratio Tail / Most Varied Capacity
