page 5
Adjusting the Side Handle (Fig. 1)
1.
Loosen the side handle slightly by unscrewing it counterclockwise.
2.
Rotate the side handle to the required angle.
3.
Tighten the side handle securely.
TOOL ASSEMBLY
The side handle can be used at the rear of the tool. Remove the handle
and install it in one of the positions provided on either side (1). Use the
side handle knob in the front handle position to secure the depth gauge
assembly (Cat. No. 845S only).
1
Installing Bits and Chisels (Fig. 3)
Spline Drive System (Cat. No. 845S)
The 845S Rotary Hammer uses carbide bits with spline shanks and
hammer steel chisels with round hex shanks.
Rotary bit with spline shank
Chisel with round hex shank
Fig. 3
Installing Chisels (Fig. 2)
Round Hex System (Cat. No. 800S)
The 800S Chipping Hammer uses hammer steel chisels with round hex
shanks.
1.
Insert the chisel into the nose of the tool. Make sure that the notch in
the shank faces toward the bit lock.
2.
To lock, push the bit lock to the right as shown.
3.
To unlock, push the bit lock to the left as shown.
NOTE: Use caution when handling hot bits and chisels.
Chisel with round hex shank
1.
Loosen the depth gauge adjustment knob (2).
2.
Slide the depth gauge rod (1) backward or forward until it is set for
the desired depth. The drilling depth is the distance between the tip
of the bit and the tip of the depth gauge rod.
3.
Tighten the depth gauge adjustment knob securely.
Fig. 1
To reduce the risk of injury, always unplug
tool before attaching or removing accessories
or making adjustments. Use only specifically
recommended accessories. Others may be
hazardous.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace and
hold securely.
1.
Insert the bit or chisel into the nose of the tool.
If you are using a rotary bit, make sure that the splines on the shank
engage with the splines inside the nose of the tool.
If you are using a chisel, make sure that the notch in the shank faces
toward the bit lock.
2.
To lock, push the bit lock to the right as shown.
3.
To unlock, push the bit lock to the left as shown.
NOTE: Use caution when handling hot bits and chisels.
Setting the Depth Gauge (Fig. 4)
(Cat. No. 845S)
WARNING!
WARNING!
2
1
Fig. 4
Fig. 2
