Kango 2500, Руководство по обслуживанию и ремонту

Страница: 8 / 16

10
Service and Repair Manual
Model 2500V
General
Hammers must be serviced at regular intervals, any indication that the equipment is not functioning as
specified, should be investigated to prevent any adverse damage occurring.
ALL SEALS, GASKETS, GREASE OR OTHER PARTS DEEMED NECESSARY FOR
MAINTENANCE ARE IN THE SERVICE KIT.
ALL NEEDLE ROLLER BEARINGS SHOULD BE PRESSED WITH THE ROUNDED
EDGE ENTERING THE BORE FIRST, AND THE INSERTION TOOL PRESSING
AGAINST THE FLAT SURFACE OF THE BEARING.
Cleaning All mechanical parts with the exception of any sealed bearings should be cleaned in a suitable cleaning
fluid. Electrical parts should be cleaned by the use of compressed air.
PRECAUTIONS MUST BE TAKEN FOR PERSONAL SAFETY THE USE OF EYE
PROTECTION AND GLOVES IS RECOMMENDED.
Inspection All mechanical and electrical parts should be inspected for wear and replaced as required.
Lubrication
At service and repair intervals the lubrication should be carried out as shown in the diagram below. All
parts in the service kit should be fitted. The total amount of grease for the 2500 is 320 grms. Lubrication
of the hammer is as shown below on the grease chart.
ALL SCREWS SHOULD BE REFITTED WITH LOCTITE ® 222 OR SIMILAR
100gm
GREASE APPLICATION CODE
GREASING PROCEDURE
Liberally coat
Pack
Generously coat
Smear
50/60 gm
20gm
40gm
20gm