15
Service and Repair Manual
Model 2500V
1.
Locate the switch box (4) with the O-ring fitted
into the top housing aperture, fit the power leads
(10) to one end of the switch (5) and the field
leads (9) to the opposite end of the switch. Locate
the switch into the switch sleeve (11), and then
locate the switch sleeve into the switch box (4).
Fit cord grip.
Note:
The switch should be in the “OFF”
position, and the slot in the switch mounting
thread should be to the top when fitting, i.e.
towards the fan.
2.
Fit the switch seal (6) to the switch (5).
3.
Fit the switch box cover (7) and secure with four
pozi-screws.
4.
Locate the switch actuator (2) through the switch
handle (8) into the trigger (3) fit the handle
assembly to the top housing whilst locating the
actuator (2) over the switch, and secure with four
capscrews.
5.
Fit the springs (1) onto the switch actuator (2)
and check switch operation.
1.
Fit the top cover (2) and secure with top cover
inserts (5) and four pozi-screws (6).
2.
Fit the gear case cover gasket, and gear case (3)
and secure with six capscrews (7).
3.
Fit handle (1) and secure with four capscrews (8).
4.
Fit switch case cover (4) and secure with four cap
screws (10).
1.
Fit the seals (5) to the piston (4).
Note:
When fitting run a screwdriver around the
piston between the seal and piston to ensure
correct seating.
2.
Fit the piston to the connecting rod (1) and push
the gudgeon pin (3) through, fit the two O-rings
(2) to the piston.
Assembling
the piston
Assembling
the switch
Fitting handle,
top cover and
gear case
cover
4
6
5
7
1
2
3 8
9
10
1
3
2
Fig. 23
1
6
3
4
2
8
9
5
10
7
Fig. 24
2
5
2
3
4
Fig. 25
1
11
Содержание 2500
Страница 1: ......
