Kango 2500, Руководство по обслуживанию и ремонту

Страница: 14 / 16

16
Service and Repair Manual
Model 2500V
1. Fit the striker (11) over the piston (9), push on
with a twisting motion.
2. Place the top barrel gasket (1) onto the top
housing.
3. Fit the barrel (3) over the striker (11) and align
holes in barrel with the holes in the top housing.
Place the retaining rings (2) in the holes and
secure with the four capscrews (12) (torque to
130Nm).
Note: When the bolts reach their torque the plastic
should be visible around the head of the capscrew.
4. Fit recoil buffer (6) into buffer housing (5)
5. Fit anvil seal (8) onto anvil (7) and assemble into
buffer housing (5).
6. Fit buffer housing assembly into barrel (3).
Note: Smear Loctite 574 joint compound between the
barrel and anvil housing before fitting together. DO
NOT USE SILICONE SEALANT.
1. Insert the plunger and latch spring (5).
2. Fit the latch (4) and press down to over come the
spring tension, push the service tool (1) through
the latch to allow the tension pin (7) to be fitted to
it, press or knock the tension pin through until
flush, expelling the service tool (see diagram).
3. Fit the lock washer and flat washer to the latch
retaining bolt (6) and pass this through the
tension pin.
4. Fit the, flat washer, and lock washer to the
threaded end of the latch retaining bolt, and fit
the castellated nut (3).
5. Tighten the castellated nut and secure with the
split pin.
Assembling
the barrel
Assembling
the nosepiece
12
2
1
3
5
6
7
8
9
10
11
Fig. 26
Fig. 27
3
4
5
6
7
2
1
2
1
3
4
5
6
7