KanexPro MX-HDBT8X818G, Руководство пользователя

Страница: 8 / 16

MX-HDBT8X818G
5
7.IR CONTROL SYSTEM (IR Call-back of Matrix and Source Devices)
The matrix is not only a switcher and
extender of multiple HDMI signals to
multiple HDMI receivers located
remotely, it also passes IR control
signals through the IR call-back system
to the matrix and HDMI sources for full,
independent control of all connected
inputs from output locations.
Two-way IR Call-back Between matrix,
Sources and Displays from Multiple
Locations.
A key feature on the matrix is discrete
IR control of the matrix, sources and
displays from any location – so inputs at
the matrix end can be
controlled at a display location and
displays can be controlled at the matrix
location. This is accomplished by placing a series of IR Emitters on devices to control and IR Receivers at all
locations you wish to control from to enable the IR signal to travel both ways via the single Cat5e/6/7 cable.
IR CONTROL IS DIVIDED INTO TWO KINDS BELOW
Insert the 3.5mm IR receiver cable into IR INPUT ports at the rear of the matrix. At the same time, insert the
3.5mm IR blaster cable into IR OUTPUT ports at the rear of the matrix. At the display, the user connect HDBT
Receiver device at the matix HDBaseT ports. Afterwards, insert the 3.5mm IR receiver cable and IR blaster cable
to the HDBT Receiver device.
① At Matrix end: When the user control the output device by remote control.
The matrix IR INPUT and the HDBT IR output is match. The way of IR control
is following video switch to change. The mean is that the HDMI input source is switched to the HDBT
receiver
output, the IR control will switch to following output select corresponding input source.
Attention: The matrix has two location HDMI outputs. If the HDMI input source
is switched to the two location HDMI outputs, the IR control will has no function.