Kanematsu Corporation TEAMNisca PR5302, Руководство пользователя

Страница: 24 / 27

22
LCD SCREEN MESSAGE PROBABLE CAUSE ACTION
time. power source is correct.
Service Call Fatal error encountered or no power
to the Heat Roller Unit. Verify the power cord is
connected to the back of the
Heat Roller Unit and the
power source is correct.
Contact your authorized
reseller for additional
assistance.
Interpreting LCD Jam Messages
If a card becomes jammed inside the Heat Roller Unit, the LCD will indicate the approximate
location of where it is jammed. Try to eject the jammed card first by pressing the Clear button. If
the card does not eject automatically, refer to the following table for a list and cause of the LCD
message.
Caution IMPORTANT! The surface of the heat rollers can exceed 150º C when in
operation. When clearing a jam, turn the power OFF and let the heat rollers cool
for at least 30 minutes.
LCD SCREEN MESSAGE PROBABLE CAUSE ACTION
Card Jam HR Unit Area11 A card is jammed in the flip/turn
unit of the Heat Roller Unit. Power OFF the printer and
Heat Roller Unit.
Open the cover to the
flip/turn unit.
Use the dial to advance the
card to a position easier for
removal.
If this error occurs again,
clean the rollers in the
flip/turn unit. See Chapter 4.
Card Jam in the Hologram
Transfer Area A card is jammed in the heat
lamp. Power OFF the printer and
Heat Roller Unit.
Open the front access cover
and flip/turn cover.
Rotate the flip/turn unit to a
vertical position.
Turn the manual rotation
knob clockwise to move the
card into the flip/turn unit.
If the card still cannot be
accessed, remove the power
cord and let the heat rollers