OWDMANUAL 1114
KAM CONTROLS, INC.
24
CAPTURING HYPERTERMINAL DATA
d: Dump Calibrations–displays calibration curves
c: Enter Calibration–this is NOT used to calibrate the OWD and is for factory use only
o: Enter offset–allows users to enter offsets manually. These should be determined by a trained technician or KAM CON-
TROLS representative.
R: 4-20mA Range–sets the 4-20mA range. See page 29 for instructions on how to change the range.
s: Save calibrations/inputs
Z: Displays all sensor values
L: Calibrate–for calibration instructions, see page 28
M: Change Modbus Address: Factory default is "1"
T/u/v/W/i: These are factory settings and should NOT be input by users
OWD PROMPTS
K A M O W D O P E R AT I O N C O N T I N U E D
Hyperterminal data can be captured in multiple ways. Users can simply "select all" and then cut and paste the data
into a word document. Or from the OWD data screen, click on "Transfer." Fig. 4-8. Select "Capture Text" from the drop-
down menu. Select and name and location for the data file, and click "Start." When you are done capturing data, click
on "Transfer" again and select "Stop."
FIG. 4-8
