INSTALLATION INSTRUCTIONS
Kallista Deep Soak Bath Cable Drain
1117994_2_A
Page 4 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INITIAL ASSemBLY
Overflow Elbow
Overflow Outlet
Coupling Nut
Compression Ring
Compression Seal
Tee
Tailpiece
Coupling Nut
Compression Ring
Compression Seal
Coupling Nut
Compression Ring
Compression Seal
Drain
Elbow
Drain Pipe
If using tee with compression joints:
Remove the overflow body, waste body, tailpiece
and tee from the packaging.
Disassemble the coupling nuts, compression rings,
and compression seals from the tee.
Assemble the drain elbow, drain pipe, tee, tailpiece,
overflow pipe and overflow elbow. Test fit the
assembly to the bathtub.
If necessary, mark and cut the drain pipe and
overflow pipe, using the dimensions in the rough-in
diagram and the rough-in information for the tub as
a guide.
Remove any sharp edges and retest fit to bathtub.
Disassemble the drain elbow, drain pipe, tee,
tailpiece, overflow pipe and overflow elbow.
Slide a coupling nut, compression ring, and
compression seal onto the overflow pipe. Repeat
this process on the drain pipe and tailpiece.
Fit the overflow pipe, tailpiece, and drain pipe into
the tee.
Hand tighten the coupling nuts onto the tee allowing
movement of the overflow body, drain body, and
tailpiece.
Do not fully tighten the coupling nuts until instructed
to do so.
If using tee with soldered joints:
Overflow Elbow
Overflow Outlet
Tee
Tailpiece
Drain Elbow
Drain Pipe
Assemble the drain elbow, drain pipe, tee, tailpiece,
overflow pipe and overflow elbow. Test fit the assembly
to the bathtub.
If necessary, mark and cut the drain pipe and overflow
pipe, using the dimensions in the rough-in diagram and
the rough-in information for the tub as a guide.
Remove any sharp edges and retest fit to bathtub.
Do not solder the joints until instructed to do so.
