INSTALLATION INSTRUCTIONS
Kallista Deep Soak Bath Cable Drain
1117994_2_A
Page 5 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALL THe wASTe ANd OveRFLOw
Apply
plumbers
putty.
Drain
Gasket
Nut
Flange
Drain
Outlet
Threaded
Cylinder
Drain Elbow
Backplate
Nut
Overflow Outlet
Overflow Elbow
Threaded
Cylinder
Overflow
Seal
CAUTION: Risk of product damage.
Do not kink or cause damage to the cable during installation.
CAUTION: Risk of property damage.
Make sure a watertight seal exists on all bath drain connections.
Apply plumbers putty to the underside of the flange.
Set the flange on top of the drain outlet.
Apply silicone sealant to the underside of the drain gasket, then place the drain gasket on top of the drain
elbow.
Insert the nut through the center of the flange and onto the threaded cylinder in the drain elbow.
Hand tighten the nut onto the threaded cylinder. Do not wrench tighten at this time.
Remove any excess putty from around the flange.
Remove the overflow seal from the packaging and position it on top of the overflow elbow.
Apply plumbers putty or other sealant to the top edge of the overflow seal according to the putty
manufacturer’s instructions.
Align the overflow elbow to the outside of the overflow outlet.
Insert the nut through the recessed side of the backplate.
Insert the nut with backplate onto the threaded cylinder of the overflow elbow.
Turn the nut clockwise until hand-tight to secure the nut with backplate to the threaded cylinder. Do not
wrench tighten at this time.
