9
Operating Instructions
Only the pressure regulator and hose assembly supplied with the grill should be used. Any replacement of
pressure regulator and hose assembly must be specified by the grill manufacturer.
Gas Consumption
To begin:
1. Make sure the grill has been leak tested and properly placed.
2. Remove any remaining packing material.
3. Light the grill burner using the
LIGHTING INSTRUCTION
below
Lighting Instruction
TO LIGHT THE MAIN AND SIDE BURNE
1. Read instructions before lighting
2. Open the lid during lighting
3. Push down and turn the control knob anticlockwise to HIGH (+), while at the same time pressing the
ELECTRONIC IGNITER button for 2-3 seconds until the burner ignites
4. If ignition does not occur in 5 seconds, turn the burner control knob(s) off, wait 5 minutes, and repeat
the lighting procedure.
TO LIGHT THE INFRARED REAR BURNE
1. Read instructions before lighting
2. Open the lid during lighting
3. Push down and turn the control knob anticlockwise to HIGH (+) and keep holding the knob for 10
seconds, while at the same time pressing the ELECTRONIC IGNITER button for 2-3 seconds
4. If ignition does not occur in 5 seconds, turn the burner control knob(s) off, wait 5 minutes, and repeat
the lighting procedure.
TO MATCH LIGHT THE GRILL
If burner will not light after several attempts using the control knob, the burner may be lit with a match.
1. If you have already attempted to light the burner using the control knob, wait 5 minutes for any gas to
dissipate.
2. Insert a match into the light rod, ignite the match and insert through the cooking grid to burner.
3. Push and turn the control knob to HI slowly, the burn should ignite immediately.
4. If the burner does not light with seconds, turn the control knob OFF and wait 5 minutes and try again.
LPG
NG
Burner
Injector
Btu/hr
Injector
Bty/hr
Main Burner
1.0mm
48,000
1.50mm
40,000
Infrared Rear Burner
1.0mm
12,000
1.67mm
12,000
