Kaivac OmniFlex AUTOVAC BATTERY, Руководство оператора и каталог запасных частей

Страница: 21 / 32

kaivac
cleaning
systems
TM
kaivac
cleaning
systems
TM
www.kaivac.com
©2017 Kaivac, Inc. All Rights Reserved
P a g e ǀ 2 1
3.4 a
uto
v
aC
o
peRation
3.0 Operation
The AutoVac feature is a walk-behind system for high speed cleaning of hard surface areas. It cleans as
well and as fast as a walk-behind or ride-on auto scrubber at a fraction of the cost.
After the unit has been filled with the appropriate
amount of water/solution, ensure that the orange
AutoVac Connector on the side of the cart is connected
in place.
Lower the Microfiber Pad and Wide-area Squeegee
Head by lifting the orange Strap on the rear handle to
unsnap it, and lower the pad and Squeegee Head.
Reattach with next button snap to hold
orange Strap in place.
To begin cleaning floor area with AutoVac:
Use Thumb Throttle to dispense solution
through the Spigot. Turn dial on Thumb
Throttle to #2. Increase if you need to
dispense solution at a faster rate.
TIP: TO USE UP THE SOLUTION IN THE PAD, TURN
THE THUMB THROTTLE TO OFF APPROXIMATELY
50’ IN ADVANCE OF FINISHING THE FLOOR
.
CAU
TIO
N:
Kee
p in
OFF
pos
ition
whe
n no
t in
use
1
3
2
4
Aut
o V
ac
OFF
Walk back and forth across the area to be cleaned, using
a three point turn approach when reaching turns, as
detailed below.
Once complete, lift the orange Strap to raise the Spreader
Pad and Squeegee Head and snap into place.
Use included Vacuum Tool to pick up any remaining liquids
or drips on the floor.
Walk forward
to end of area
being cleaned.
Continue
turn. Overlap
previous pass.
Pull back
and begin
turn.
Begin turn.