KAESER KOMPRESSOREN SIGMA CONTROL SMART M114, Руководство оператора

Страница: 152 / 364

Fig. 64 Cleaning the filter element
1
Compressed air gun with blast pipe bent to 90° at the end
2
Filter element
➤ Open both doors.
Checking the contamination level of the air filter
Air filter maintenance is necessary when the yellow piston inside the maintenance indicator rea‐
ches the red zone.
➤ Check the air filter maintenance indicator.
If the yellow piston reaches the red zone, Clean or renew the filter element.
Cleaning the air filter:
1. Release the retaining clamps, lift off the cap an extract the air filter.
2. Carefully clean the inside of the housing, the cover and sealing faces with a damp cloth.
3. Cleaning the filter element:
■ Use dry compressed air (≤ 72 psig!) at an angle to blow dust from the element from inside
to outside until no further dust develops.
■ The blast pipe must be long enough to reach the bottom of the element.
■ The tip of the blast pipe must not touch the element.
■ Clean sealing faces.
4. Inspect the element carefully for any damage.
Damaged filter element: Replace filter element.
5. Insert the cleaned or new filter element into the filter housing. Make sure it is properly in place
and sealed by its gaskets.
6. Replace the cap and secure with the clip.
Resetting the maintenance indicator
➤ Repeatedly press the reset knob on the maintenance indicator.
The yellow piston within the indicator is reset and the maintenance indicator is ready for use
again.
➤ Close the doors.
Dispose of old parts and contaminated materials according to environmental regulations.
10 Maintenance
10.5 Compressor Maintenance
140
Operator Manual Screw Compressor
M114 SIGMA CONTROL SMART
No.: 901765 05 USE