blueplanet hybrid 10.0
Page 18
6.3
Unpacking the device
CAUTION
Property damage as a result of condensation
Faulty storage can form condensate in the device and impair the device functioning (e.g. storage outside
the ambient conditions or temporary relocation from a cold to a hot environment).
›
Prior to installation, check the inner area for condensation and if necessary, allow it to dry sufficiently
before installation.
Unpacking the device
1.
Loosen packaging tape from cardboard box.
2.
Open the carton at the top. Be careful not to damage the device when using sharp objects.
3.
Remove installation material and documentation.
4.
Reach through the housing and slide the device out of the carton.
5.
Remove the protective packaging from the housing.
6.
Remove the wall bracket from the back of the device by loosening and removing the locking screws
according to Fig. 6 [ T_TX20/
1.5Nm].
Fig. 6: Position of the locking screws
6.4
Securing the wall bracket
CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be
seriously injured.
› Use only fixing materials that are suitable for the mounting base.
›
Only install the devices upright and side by side.
EN
