Kabuto Japan RT33, Инструкция по эксплуатации

Страница: 12 / 29

– How to attach the shield –
  
A

WARNING!
CAUTION!
•Do not push or twist the shield by force when installing it. Such action may
damage the shield and ratchet system.
•After installation, be sure to pull it lightly towards the removing direction to make
sure that it is securely installed.
•After the installation of the shield is completed, open and close the shield three to
four times to make sure that the shield works properly.
•After the installation of the shield has been done, make sure that the shield
is securely installed and that it is properly opened and closed before riding.
If the shield does not work properly, or is installed insecurely, it may cause
a failure in opening and closing the shield or lead to the removal of the
shield while riding, thereby causing a great risk. If the opening and closing
operations are not properly performed or abnormal noise is heard during
these operations, check the steps in the installation procedure and repeat the
installation procedure from the start.
•The shield is a consumable item. If the shield surface is damaged by a bug,
stone, etc., it may hinder the vision, thereby causing a great risk. If the shield
gets extremely dirty or scratched, replace it with a new one.
ENG-10
Release Button
Hook on shield
mechanism
Shield
Hook on shield
mechanism
Cover the Shield
Ratchet
First, stop at this
position
Hook of Shield
Ratchet
Then
insert the
shield in the
direction of
the arrow as
far as it goes
Shield Ratchet
Same angle
Shield
1. As shown in

and

, align the angles of
the shield release button and the part
A
on
the Shield Ratchet, and set the mechanical
part of the shield on the ratchet as shown in

.
2. Insert the shield in the direction of the arrow
as far as it goes, then the shield can be
attached. Follow the same procedure to
attach the shield on the other side.
(

The installation of the shield is complete).
ENG
A
Hook of Shield
Ratchet